I have the parameters but not the procedure to initialize and clear the T1 control before re-entering them.
Would appreciate any help.
Thanks
I have the parameters but not the procedure to initialize and clear the T1 control before re-entering them.
Would appreciate any help.
Thanks
How to clear asterisks on T1. You will need to take note of parameters first.
to clear all rubbush on T1
Press MENU key. Press Param. press PAGE, bring cursor to OP12, press
111111118 IMPUT
Power off/on
To clear tool data
Press MENU key
Press T-Data
Press 8th button from left
press CLEAR key
To clear "Tool set"
Press menu key
Press T-SET
Press 9th key from left
Press CLEAR key
To clear cutting conditions
Press MENU key
Press C-COND
Press 9th button from left
Press CLEAR key
To clear "Programme"
Press MENU
press PROG
press ALL ERASE
press INPUT
To clear parameters
press MENU key
press PARAM
press 8th button from left
press CLEAR key
press PAGE menu
press 8th key
press CLEAR key
To load all information
bring cursor to A7
press 16 then INPUT to set baud rate
bring cursor to OP2 and press
000000101 then INPUT (to set CMT available
Power off/on
If you have CMT or micro disk or Griffo with info on it, connect to machine.
Press MENU
press DATA IN OUT
press DATA IN
press 123456
press INPUT
the CMT will load all information
otherwise you will have to load it manually.
to load parameters OP1/16, there are 8 digits 0 or 1, if there are 2 "1" on line type 2 as 9th digit etc