I am having some issues with a program we were running in the shop here; I edited the code to move the hole location by -.016" in the Y axis. I will post the original to the current. I cannot figure out why it is alarming out on me but I have not been too great with understanding I, J, K since I had first left my classes involving them. Below is the code:
Revised for Y move code:
N800 T8 M6
N820 G0 G90 G58 X-2.016 Y-0.016 A90. S5500 M3
N830 G43 H8 Z5.8425
N840 Z4.0425
N850 G1 Z3.8425 F25.
N860 G41 D8 X-1.6405 F40.
N870 G3 Z3.7925 I-.3755 J0.
N880 Z3.7425 I-.3755 J0.
N890 Z3.6925 I-.3755 J0.
N900 Z3.6425 I-.3755 J0.
N910 Z3.5925 I-.3755 J0.
N920 Z3.5425 I-.3755 J0.
N930 Z3.4925 I-.3755 J0.
N940 Z3.4425 I-.3755 J0.
N950 Z3.3925 I-.3755 J0.
N952 Z3.3425 I-.3755 J0.
N960 X-2.132 Y.3611 Z3.3275 I-.3755 J0.
N970 X-1.6405 Y-0.016 I.116 J-.3571
N980 X-2.132 Y.3611 I-.3755 J0.
N990 G1 G40 X-2.016 Y-0.016
N1000 G0 Z5.8425
Original Code:
N800 T8 M6
N820 G0 G90 G58 X-2.016 Y0.0 A90. S5500 M3
N830 G43 H8 Z5.8425
N840 Z4.0425
N850 G1 Z3.8425 F25.
N860 G41 D8 X-1.6405 F40.
N870 G3 Z3.7925 I-.3755 J0.
N880 Z3.7425 I-.3755 J0.
N890 Z3.6925 I-.3755 J0.
N900 Z3.6425 I-.3755 J0.
N910 Z3.5925 I-.3755 J0.
N920 Z3.5425 I-.3755 J0.
N930 Z3.4925 I-.3755 J0.
N940 Z3.4425 I-.3755 J0.
N950 Z3.3925 I-.3755 J0.
N952 Z3.3425 I-.3755 J0.
N960 X-2.132 Y.3771 Z3.3275 I-.3755 J0.
N970 X-1.6405 Y0.0 I.116 J-.3571
N980 X-2.132 Y.3771 I-.3755 J0.
N990 G1 G40 X-2.016 Y0.0
N1000 G0 Z5.8425
If anyone could review this and let me know what they see that could be causing this alarm that would be awesome. As of now I cannot tell what the issue is. I am sure it is something with an incorrect start/stop of radius point but like I said I am not good with I, J, K values.