My X2 Mill stopped working. On examining the XMT-1135 Controller board I can see that the large Resistor in the middle of the board is fried - liquid had oozed out of it. I was able to remove it. It came out easily with a slight touch of a fine-tipped soldering iron on the underside of the board.

Not being an electrical expert, I don't know what to ask for when ordering a new one. I've search hi and lo for a circuit diagram of the xmt-1135 but can't find one.

The resistor is about an inch long, about 3/8" in diameter and tan in color. The color rings appear to be orange, lime-green, red and green again.

Does anyone happen to know the specks of this large resistor on the xmt-1135 so I can order a new one?