My Current setup is Gecko G540 and Mach3
I recently purchased a OPTLASER PLH3Dlaser and am having issues connecting it to the Gecko.
They state that this can be controlledthrough the PWM connections.
I have 3 wires that come off the laser
white - Analoginput 0-5V laser power is proportional to the voltage given on this input
grey – TTL in0-24V all voltage given over 3V on this input gives maximum power and allvoltage below 2,5V gives no power
yellow –Analog/TTL GND
My issue iswhere do these wires go and how to config Mach3 to see the laser.