Hi All,
I have a strange issue with the G03 command, sometimes it will not cut the circle, it moves to the location but does not do the cut.
I was playing with some test code and found the following:
Works:
G00 x2.15 y10.4789
G03 x2.15 y10.4789 i0.0 j0.65 f20.0
Does not work:
G00 x2.16 y10.4789
G03 x2.16 y10.4789 i0.0 j0.65 f20.0
Less than .15 works more than .16 on the x does not work. WTF?
This is in Mach 3 connected to a Kflop/Kanalog system.
Any thoughts?
Cheers
Chris