Right now my spindle is a sharpie
When I draw the roadrunner, its tiny, maybe 1.5 inches
Can someone point me to where I'd start to enlarge the RR to say 12" X 12"
Thanks all
cncneon
Right now my spindle is a sharpie
When I draw the roadrunner, its tiny, maybe 1.5 inches
Can someone point me to where I'd start to enlarge the RR to say 12" X 12"
Thanks all
cncneon
Roadrunner is about 8x8 inches in its stock condition. It sounds like you need to set the machine calibration.
https://www.youtube.com/watch?v=xLUViu65qXg
Jim Dawson
Sandy, Oregon, USA
Otherwise, on the right side of each axis DRO, you can set a scale factor. Just remember to set it back
Dave
In the words of the Toolman--If you didn't make it yourself, it's not really yours!
Remember- done beats perfect every time!!
Thanks, both answers helped a bunch. Calibration. . . duh, don't know how I missed that.
Actually I do, my learning curve has looked a lot like a ping-pong ball in a blender.
The scale thing I'll get into after I get my machine properly calibrated.
Again, really appreciate all who took the time to help a newb
cncneon