Hi All,
I'm Terry, I don't normally post here, I spend most of my time on the Tormach forum, but I have Fusion 360 question that has me stumped.
I am working with some small AL blocks (4" sq by 1/2") that already have the edges finished. However I want to add a 1/2" radius fillet to one corner.
I am trying to use a 2D contour to make the cut, but what I can't figure is how to limit the tool path to just the radius of the fillet, it wants to cut the entire perimeter of the block, which in not only not needed but makes clamping a problem.
Any suggestions would be most appreciated.
Terry