585,591 active members*
2,609 visitors online*
Register for free
Login

Thread: 3 Phase Conversion question

Results 1 to 2 of 2
  1. 05-20-2007, 05:25 AM #1
    Rich05
    Rich05 is offline Registered
    Join Date
    May 2007
    Posts
    327

    3 Phase Conversion question

    I have seperate breakout for 220 with 2-20 amps, and one 30 amp breaker. I am thinking of getting a $500 3 phase rotor conversion. Will this give a reliable and safe 3 phase power for my 5 hp CNC machine? Or do I have to get a 3 phase drop to my home?

    thanks R.
    Reply With Quote Reply With Quote
  2. 05-20-2007, 06:55 AM #2
    Newby2
    Newby2 is offline Registered
    Send a message via Yahoo to Newby2
    Join Date
    Nov 2006
    Posts
    154
    R... Check out www.Phaseconverter.com for the size you require. I purchased mine fron them and run a Bridgeport R2E3 with it. Before you decide on the size you buy, determine what your requirements will be.
    Steve
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 4 phase input to Step/Dir conversion?
    By Konstantin in forum CNC Machine Related Electronics
    Replies: 12
    Last Post: 02-11-2007, 05:40 AM
  2. Phase Converter Question
    By bherr in forum Phase Converters
    Replies: 11
    Last Post: 11-02-2006, 07:02 PM
  3. 3 phase bypass question
    By Chris64 in forum MetalWork Discussion
    Replies: 5
    Last Post: 09-09-2006, 05:07 PM
  4. 120/208 Y-Config. Motor phase conversion
    By gtslabs in forum CNC Machine Related Electronics
    Replies: 1
    Last Post: 06-17-2004, 02:18 AM
  5. amps/phase question
    By CNC Brute in forum CNC Machine Related Electronics
    Replies: 1
    Last Post: 12-04-2003, 05:00 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules