I'm using a PCI parallel port card with Linuxcnc but I can't get it working with my Gecko G540. I want to try switching it to EPP mode but I can't see any options for that anywhere.
please can someone tell me how you switch to EPP mode with a PCI parallel port card?
There is nothing in the motherboard bios which is no surprise as it's an add on card.
Results 1 to 11 of 11
Threaded View
-
04-07-2019, 07:21 PM #1
Registered
- Join Date
- Mar 2017
- Posts
- 926
How do you switch the parallel port to EPP mode in Linux?
Reply With QuoteSimilar Threads
-
Linux / linuxcnc can't see my parallel port card
By Goemon in forum LinuxCNC (formerly EMC2)Replies: 19Last Post: 04-07-2019, 12:51 AM -
parallel port dead with pc-suggestions for purchasing usb/ethernet to parallel port?
By curiosity22 in forum Australia, New Zealand Club HouseReplies: 48Last Post: 08-19-2015, 11:32 AM -
no new computers have parallel?? experience on adding parallel port yourself?
By teglberg in forum Mach Software (ArtSoft software)Replies: 1Last Post: 11-26-2014, 07:18 PM -
parallel port or parallel universe
By bruno34 in forum Taig Mills / LathesReplies: 5Last Post: 04-15-2009, 04:58 PM
Tags for this Thread
Posting Permissions
