Re: Replacing GO704 table. Will it work?
Originally Posted by
moto52000
That is a good idea actually. Seems that the table is sacrificial in my shop anyway.
Is it even possible to fix this? Brazing, welding?
I don't think I would weld or braze the table, it might warp.
We have a semi-permanently attached 1 inch thick aluminum tooling plate on our Haas. Works very well. We waxed the table with a few coats of paste wax before installing the tooling plate to protect the table from any coolant that might get under it. As a bonus, it allows easy use of interchangeable pallets that are located by pin holes in the tooling plate.
Jim Dawson
Sandy, Oregon, USA