we just purchased a new Cincom Citizen L32 with Mitsubishi controls from a dealer who is un-knowledgeable about setting up FTP on it. We want to use Ethernet instead of RS-232. Does anyone know the step by step procedure to get an Mitsubishi m700 to send information back and forth to a PC via Ethernet cable?
i tried using the other post on here but it did not have the same controls.
i tried going through parameter settings by pressing
-MAINTE twice
then
-param
then there wasn't any way to find an "Ethrnet param soft key"
please help!
Results 1 to 3 of 3
-
04-12-2019, 04:51 PM #1
- Join Date
- Apr 2019
- Posts
- 1
how to talk to m700 with PC by Ethernet?
-
05-05-2019, 03:31 PM #2
Registered
- Join Date
- Sep 2017
- Posts
- 139
Re: how to talk to m700 with PC by Ethernet?
The software and parameter for standard M700 is different from Citizen M700.
However please check the below list of parameter
-
07-13-2023, 09:56 PM #3
- Join Date
- Jul 2023
- Posts
- 3
Re: how to talk to m700 with PC by Ethernet?
Any luck with this. We are trying to get a Citizen m700 to do program transfer.
Reply With QuoteSimilar Threads
-
anyone familiar with the mitsubishi M70 or M700??
By aminoovitch in forum Mentors & Apprentice LocatorReplies: 0Last Post: 03-17-2016, 03:58 AM -
Redsail M700 Laser cutter / engraver experience
By jouellet in forum Laser Engraving / Cutting Machine General TopicsReplies: 19Last Post: 11-19-2014, 12:04 AM -
Sprutcam 7 postprocessor for Mitsubishi M700 controller
By Abs9 in forum SprutCAMReplies: 3Last Post: 05-01-2014, 07:40 PM -
Acrylic block Redsail M700
By Roque7 in forum Redsail LaserReplies: 0Last Post: 03-07-2013, 01:42 PM
Tags for this Thread
Posting Permissions
