For a part with small holes, or the part space is small than the extry length, there is the possibility of cutting interference, because the default extry/exit (lead in/out) type is set for normal size part and holes. CutLeader would auto detection the problem now.
[ATTACH=CONFIG]418384[/ATTACH]

User don't need to correct them one by one, thanks for the "Perform Interference Check" option in sequence page, CutLeader would auto detect and correct the entry/exit when running the Auto Sequence command. The interference would be avoided by adjusting the position or shorten the length of lead in/out.
[ATTACH=CONFIG]418386[/ATTACH]

Here is the result after adding sequence.
[ATTACH=CONFIG]418388[/ATTACH]