I have v26 is there options for using a drag knife and adding corner actions??
if not, is there free software out there for doing this?
thx
I have v26 is there options for using a drag knife and adding corner actions??
if not, is there free software out there for doing this?
thx
I remember seeing this discussed on the Mach3 support forum, it may be worth searching there for "Drag Knife", I didn't read in any detail as my only application would be vinyl stickers and I use a vinyl plotter for that.
Not for V26, it does now exist in V31 though but that would cost a chunk of change to upgrade from V26 to V31
However you could try the software at this link to a free software that might do the job for you, it does say that it supports Drag Knife operations
https://sourceforge.net/projects/dxf2gcode/?