Hello all,

I Need some help with my Servostar S346. I would like to drive a milling spindle with the s346 amplifier.
I have wired the motor and the driver as it says in the manual (minimum wireing).
In OPMODE 0 the motor is running fine. If I change into the OPMODE 1 (analog speed), i cannot set the
SW-ENABLE. In the manual it says, that no SW-ENABLE is needed for OPMODE 1.
I put a voltage on X3/3-4, but the motor does not move. The setting for ANCNFG is 0.

What is wrong? Please help