I am in the process of switching from Mach3 to UCCNC. I first had a setback trying to get my SuperPID to work properly but now have that pretty well set. I also purchased the newer XHC pendant but found that there was no driver or plugin to use it in UCCNC so I returned it and decided to get one that was fully support. Even though it was more than what I had planned to spend I went for the VistaCNC P4-s pendant. But I still have a problem. I cannot get the configuration page to open to set options.
I copied the plugin to the plugin directory
Enabled it
Restarted UCCNC and go to configuration page. When I click on the Configuration button, nothing happens. No new window or pop up window appears. The pendant does work for some things. I can jog, although step jogging is a bit jerky. Spindle start and start work and I can adjust spindle speed and feed. But with out getting into the configuration I can't fine tune or set screens or macros.
Any ideas why the configuration page wont open? I emailed VistaCNC but haven't heard back. I also posted in the UCCNC forum.
Windows 10
UCCNC 1.2049
UC300ETH
VistaCNC p4-s
Sam