After reading a few posts about the advantages of using hall sensors I have ordered some for my CNC.

Instead of the bare A3144 sensor I ordered it as a module, thinking it would save me some time and make for a better signal, but I’m not sure, so I need some advise.
Here’s the module from Amazon.
?
https://www.amazon.com/dp/B072VVRNB7..._0Ek0CbZTZWECE

Looks like I just need to supply 5 VDC and ground to power it, and connect it to the appropriate pins on the control board.

Could someone make me a simple drawing showing labeled connections? If it can show point to point connections for one axis I can figure it out for the rest.