Hi all.

RE: D.Electron Z32 CNC Rotary Laser Cutter.

I’m a PC engineer and was asked by a very desperate CNC owner to look at a PC in a CNC system, I found that the battery on the CNC-Link card (PCI board with two optic fibre nodes) had failed, so I replaced it which corrected the original error, but now the CNC table goes beyond the point at which it should stop and I get an error saying “multiple CMOS errors”.


Will the CMOS in the CNC-Link card have now lost it's settings and need re-initializing? If so, is this normally done through the CNC software or is there normally a restore tool of some type?


Sorry if this question doesn't even make sense, I know very little about CNC. Any help would be much appreciated.

Thanks.

Steve.