I need this for a simple mock up job. Either Laser Cut or probably better would be waterjet from steel plate, or CNC from thicker Aluminum. I just need it to be stiff enough to make sure my dimensions and stuff are correct, so I think 3/16" Plate (maybe even 1/8") or 1/4" Aluminum would be fine.
Units are mm, the lower holes are 192mm apart, the closer ones are 140mm apart, and they're 8.5mm offset.
I need 1 piece for sure, maybe 2 depending on cost.
Message me here, or post here. Need these sooner than later.