[Kristjan1505]

Hi everyone .,

Ok , im not sure if my title tells anything , but not sure how to name that problem..

Lets say that i got a wooden board that is 1 inch thick , im make a pocket that is 6 by 6 inches and ½inch down.

Now if i want to make a slit or a hole in the bottom of my pocket that goes through the material what do i do ?

Cause my current solution is just to make a new pocket but then i need to make the cutter start at 1 inch instead of starting just above the ½inch pocket i already made ?

And yeah , im pretty new with aspire

Thx in advance ,

Kris

[ZASto]

You should read the manual

Attachment 420520

First pocket:
Attachment 420522

Second pocket:
Attachment 420524

Pay attention to depths

[Kristjan1505]

You should read the manual



First pocket:


Second pocket:


Pay attention to depths

Now dont get cocky :cheers: hehe ,

Oh my god , i have been staring at it so many times , but hey.. NOOOOOOO dont read manuals , learn by doing right ....

I looked at that section so freaking many times you wouldnt even fathem it... but ok , now i know what it is and THANK YOU SOOOO MUCH:... he he

Cheers mate ,