Does anyone have the manual for VFD manual for MK100-2S2.2G-DK
Have attached pic of the manufacturer plate
Thanks
Does anyone have the manual for VFD manual for MK100-2S2.2G-DK
Have attached pic of the manufacturer plate
Thanks
Mactec54
This saved the day for me cheers for the manual. Which setting if to allow Mach 3 to control the spindle speed?
Hello,
I have a CNC6040Z S80 with a MK100-2S2.2G-DK in the black box.
In the manual there is no info about RS485 / Modbus protocol...
I have modified:
P0-02 to 2 for communication command channel
P0-03 to 9 for communication command for frequency control
Modbus rtu request:
with 01 06 20 00 00 01 I can RUN
with 01 06 20 00 00 05 I can STOP
But
with 01 06 20 01 0F A0 i can't modify frequency.
Did I miss something ?
or Have you modbus documentation
thanks a lot
Laurent
excuse my english i'm french
Hi,
i have a question for the frequency inverter MK100-2S1.5G-DK. I want to start my Spindle via CNC Software. My CNC6040 is from the Vendor "SXCNC".
Has anyone ever wired the frequency inverter to the mainboard JP-3163B?
Can you have a look to my Post here i worte all in details about my question?
https://www.cnczone.com/forums/chine...ml#post2402392
Regards Raini
Hi a buy an chinazone CNC 3040Z-DQ 4-axis Router 800W Engraving Mach 3 USB Cutting Engraver Machine on ebay a while ago and havent been able to do anyting with it until now so a have done everything clear to start up the machine and try it out and check if stepper motors and spindel runs as it shud do, and a so far a have get the stepper motors to run ,but not the spindel motor?
a have been looking all over to find help how to setup my VFD so the spindel start runing.
a did not find any macth on the VFD controler panel anywhere a have looked so a desided to open it up and se innside to find out wicth VFD it had and find out that it is an MK100-2S1.5G-DK so there was an other question poping up??this is an VFD to 1.5kW spindel motor and the spindel a got is an 800W spindel motor eehh ok???
Is that a problem??or can it be fixed changeing the parameters on the VFD to fit the 800w spindel??
my software is Mach3 running on windows10,there is an mainboard MKS4-V in the controller box.
so can anyone her help me how to setup this VFD to getting the 800w spindel start running on mach3? how this is done step by step with the VDF?
And how to setup the end limit switches to functions proporly?
A have been very happy to get some help getting this machine up and running
thx dontworry21