585,715 active members*
3,806 visitors online*
Register for free
Login

Thread: Milltronics ramping

Results 1 to 2 of 2
  1. 06-03-2019, 04:01 AM #1
    positiverake
    positiverake is offline Junior Member
    Join Date
    Sep 2005
    Posts
    272

    Milltronics ramping

    Hello, this is a 2003 vm25 with Milltronics Centurion 7 control, when I use the clear pocket for a slot and tell it to ramp for Z it does a helical circle at the Z depth of cut? and if I change the ramp angle it dont change, what am I doing wrong? also it does the helical circle on the edge of the slot and will leave a witness mark, sometimes I dont want to run a finish pass and just rough to size, is there a way to change this? thanks
    Reply With Quote Reply With Quote
  2. 06-05-2019, 12:03 AM #2
    positiverake
    positiverake is offline Junior Member
    Join Date
    Sep 2005
    Posts
    272

    Re: Milltronics ramping

    Nothing? ok how about this, does anybody know were the spindle bearing purge drain hole is and how to check if its working?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Ramping V24
    By zachf in forum BobCad-Cam
    Replies: 0
    Last Post: 01-26-2012, 11:32 PM
  2. Ramping down
    By dazzer in forum Bridgeport / Hardinge Mills
    Replies: 2
    Last Post: 11-29-2008, 02:26 AM
  3. ramping
    By truefordlover1 in forum BobCad-Cam
    Replies: 4
    Last Post: 08-01-2008, 06:28 PM
  4. Ramping
    By pauls in forum BobCad-Cam
    Replies: 1
    Last Post: 03-04-2005, 10:49 PM
  5. Ramping example?
    By inthedark in forum G-Code Programing
    Replies: 5
    Last Post: 04-10-2004, 02:53 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules