[ericks]

Hope the owner comes through

I started downsizing my plans 4x4 eats up to much space
i really don't need it that big and if i do i will go see my buddy down the road

best of luck
Kelly

3 by 3 or rails and screws that fall within range
the one foot gives me working room
i need a bigger shop or less stuff " Hobbies, Projects, Repairs some might call them "get to them later stuff""
I am leaning toward the G540
I just received an ESS Ethernet to connect to my Hobbycnc chopper board so I can run Windows 10
My lpt port is out on my xp box and its slow and old
I am planning to run the G540 with it when I upgrade.
with new motors, power and spindle.

Your work has been inspiring

He basically have to cause i have his machine

The G540 seem to be a good unit, i just ordered one today, need to make up a pcb for faster connecting of wiring.
This machine i am working on still runs of the printer port, he's bringing it around for me to sort cause he could not get it to work.
I think i will modify his panel so that he has the option to do a quick upgrade to a motion controller if required.

Thanks for the compliment

[ericks]

No work done on the mechanical....however there will be some changes to the control box. Reason for this is electrical safety and cost. I was going to have dual IEC filtered supply point/sockets due to the VFD in the box. This would have meant a four pole panel mount isolator would be required. In the photo i temporarily installed a three pole. After some testing i have decided to use a single 20A IEC filtered socket to supply everything in the panel. Thus the existing isolator is fine....Also the gland plate entries will change and some of the wiring, i did this to allow for easy upgrading. The HY drive will be replaced with a more compact 2.2KW drive. This will free up space for other bits, he is already talking about a fourth axis, so i will add a leadshine drive