585,975 active members*
4,566 visitors online*
Register for free
Login

Thread: CNC Controller not powering up

Results 1 to 2 of 2
  1. 06-08-2019, 11:19 AM #1
    Rkjt
    Rkjt is offline
    Join Date
    May 2019
    Posts
    4

    CNC Controller not powering up

    I think I might have burnt out the controller. I had the z axis too low and the bit resting hard on the wood when I turned on the spindle, I thought it was just off the wood but I didn’t notice it, now there is no power in the controller at all. I checked the fuse, and the only fuse I could find was on the power board, but it was ok. Does anyone where the problem could lie?
    Reply With Quote Reply With Quote
  2. 06-08-2019, 01:21 PM #2
    john-100
    john-100 is offline Registered
    Join Date
    Mar 2007
    Posts
    2083

    Re: CNC Controller not powering up

    have you checked the fuse in the IEC mains inlet ?
    Attachment 421876

    if the fuse in the inlet is OK,
    the mains ON /OFF switch should be Illuminated when switched on

    John
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Powering Mk3/4
    By theRat in forum PlanetCNC
    Replies: 1
    Last Post: 09-17-2017, 01:16 PM
  2. Fanuc 18 M not powering up
    By handyman in forum Fanuc
    Replies: 13
    Last Post: 02-05-2017, 08:48 PM
  3. FADAL VMC15 Powering up to AXIS CONTROLLER DOES NOT RESPOND and cant get past it
    By machinedmachines in forum Fadal
    Replies: 3
    Last Post: 03-15-2016, 09:26 AM
  4. Powering up an older KM3
    By rbalister in forum HURCO
    Replies: 9
    Last Post: 06-23-2011, 01:26 PM
  5. powering down the control
    By Joe Miranda in forum Milltronics
    Replies: 3
    Last Post: 04-13-2008, 02:48 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules