Hi All -
I'm new here and need some help on the feasibility of milling some polycarbonate plugs. My current method of production is turning down 5/8" Polycarbonate rod on a lathe and then parting. These plugs are backed by a carbon fiber plate (2mm) and it's time consuming to part, glue backing, clean up, then part again.
I've attached a picture of the final product for reference.
I'd like to be able to CNC mill a sheet of the carbon plate backed Polycarbonate but I'm not sure if this is even doable.
Specs:
Each Plug final dimensions should be 14mm in diameter and approx 11mm in thickness.
Any input is greatly appreciated.
Thanks,
Phil