Hi all,

I recently purchased a new cheap 60W Chinese laser cutter, and the up and down buttons aren't working. I'm pretty sure the reason they aren't working is because they are missing

My question...since I don't know how long it will take to get a new control panel (one that at least sort of matches the eBay picture), is there a way to raise and lower the bed using software? For example, can I use laserdrw? I've searched through posts, and it seems most issues are because the buttons don't work, not because they are missing.

Thanks!

Board: 6C6879-LASER-M2
Fireware (hoping they meant firmware): 2018.06.18