I had a weird glitch today while setting up a job.
While setting up my 770, (Pathpilot V 1.9.13), I was jogging my edge finder in .001 mode, about to touch my edge,
when suddenly the machine goes "CLICK! CLUNK!!!" … and all motion stops.
The computer screen was still on... no alarms, but the mouse no longer worked, and no motion in jog.
Everything was still on, but it seemed to be in E-stop mode?
Very odd.... No movement or response at all.
So, I had to do a hard-shut down. Turned off the computer. Waited 60 seconds, and fired everything up again.
After re-starting & referencing, everything seemed to be working like normal, EXCEPT all of my Tool offsets reverted back to the past settings?
Very odd...……….
Any ideas on which kind of Gremlin got into my machine?
Has anyone experienced this before?
Thanks! -Russ