Re: OSP Data Card
hi cg / " What is the difference between Tape Store and Prog.Capa? " tape store is a system device, thus a path from where the controller can load program files; tape storage size should be >= program capacity, so to allow you to load a maximum sized program, so to take advantage of full potential of the program capacity
program capacity is a cnc constant ( capability ), and the tape is an input; this input should allow you to use the capability at full potential; for eg, if maximum program size is 2 mb, and tape storage is 500kb, then you may not use the cnc at full potential; in reverse, if the maximum program size is 500kb, and tape storage is 2mb, then you may store on that tape device only 4 programs with size = 500kb, or 8 programs with size 250kb; also, you may store only 2 programs with size 1mb, but the controller won't be able to load/select them, because their size is > program capacity / kindly
Ladyhawke - My Delirium, https://www.youtube.com/watch?v=X_bFO1SNRZg