Hello CNCzone Community,

I'm encountering a challenging issue with my EMCO Turn 325-II lathe.
Recently, I've been receiving the error message: "Reception of message 0x0 failed with error 2".

Interestingly, when I dismiss this message, the WINNC software (Siemens Sinumerik 840D version) continues to run, but the lathe itself stops responding to commands.
I've found that restarting the WINNC software alone (not the entire computer) temporarily resolves the issue.
However, the error message reappears after some time, and the lathe ceases to respond again.
Does anyone have experience with this specific error or know what might be causing it?

I'm looking for suggestions or solutions to tackle this problem.

thank you for any assistance or advice you can provide!