[dlaery]

I have a part that needs to be milled on the top and then turn to where the side faces up and then mill that side.
I don't know where to look in help how to do a different setup.
Where do I start to find out how to do this?, is this in the "stock wizard"

[magicniner]

Use Work Coordinate Systems, it's mainly down to planning, reference points on work, stock or both, work stops and accurate set up though.

[magicniner]

If your machined side doesn't lend itself to be being held in a vice for the second op you can machine a soft jaw which will support it derived from your part geometry or that of the machined stock saved from a completed simulation run.

[dlaery]

thanks, i found a video by Depoalo of "Multiple Machine Setups "
https://www.youtube.com/watch?v=bVJYIbMmaVs

this is what I was looking for, this makes it look easy but I am having some trouble with my orgin.
I think I can get it now.
Thanks!

[dlaery]

I actually got it to work:wee:

[magicniner]

Excellent, that's great to hear!