Newb here.
I bought a package off of ebay that came with a 36V power supply, and stepper drivers rated from 18-50VDC
The 425 oz/in Steppers have the following specs:
Part No.: 57BYGH115-003B
Frame Size: NEMA23
Step Angle: 1.8 degree
Voltage: 6.3VDC
Current: 3 A/phase
The voltage is listed at 6.3VDC - so I have questions....
They came as part of a kit, so I assume they are meant to work together....
What happens if you run steppers at a higher voltage than the nameplate voltage? Do they run hot? Burn Out? Release the magic smoke?
What voltage would you recommend I use for these motors? Or should I replace them with higher rated ones?
Thanks in advance.