Strange situation but I am looking to tie an input and output to my Bodor i3 from a Siemens PLC. The issue is that we do not have the original source code for the laser. Therefore no logic changes can be made. The specific signals we need would be an input to the i3 for Cycle Start and an output from the i3 for Cycle Complete. Is there a general location to look for if we wanted to view the available inputs and outputs and what they do so we can tie them to a Siemens PLC? I can provide screenshots if needed. Bodor has not been able to support me on this issue. Any suggestions would be helpful, thanks.