508,135 active members
3,144 visitors online
Register for free
Login
IndustryArena Forum > Machine Controllers Software and Solutions > UCCNC Control Software > How to configure a soft stop button - Not E-stop
Results 1 to 2 of 2
  1. #1
    Member
    Join Date
    Feb 2012
    Posts
    119

    How to configure a soft stop button - Not E-stop

    I have been trying to come up with a soft stop for a while now and the solution is not coming to me. Looking for ideas.
    I have UC300eth-UB1, UCCNC, DMM Dyn4 servos.
    I have wired the UB1 with a push-pull estop, charge pump, safety relay, and a contactor. The safety circuit works well and as expected.
    I have two momentary switches (on & stop). I use the on to set the safety relay and energize the contactor. Currently, I have the momentary stop wired in the e-stop circuit, so I can stop with out using the estop button.(even though it still performs the same function as killing the power)
    I want to use the enable inputs of the drives as well as the (WJ200 VFD) to create a soft stop, instead of killing the drives power every time I want to shutdown. I feel it would be better to have a controlled shutdown, but I am not coming up with a good solution. I could swap the momentary with a latching switch and wire to the UB1 inputs, but how do I connect the switched input with the needed output to open the drives enable circuit? Any input?

  2. #2
    Registered
    Join Date
    Jun 2015
    Posts
    871

    Re: How to configure a soft stop button - Not E-stop

    You can add a stop function of the UCCNC in the input triggers.
    That attaches the stop function call to an input pin state.
    The stop function makes controlled stop.

Similar Threads

  1. ESS with MB2: How to configure K1 to start/stop Spindle
    By Sterob in forum SmoothStepper USB Motion Control
    Replies: 9
    Last Post: 06-08-2018, 03:29 AM
  2. Limit Stop and Soft Stop MPC6515 and LaserCut5.3
    By JHamilton in forum General Laser Engraving / Cutting Machine Discussion
    Replies: 25
    Last Post: 10-22-2013, 03:19 PM
  3. E stop button
    By 85burban in forum Tree
    Replies: 5
    Last Post: 02-23-2012, 12:57 PM
  4. E-Stop Button
    By widgitmaster in forum General CNC Machine Related Electronics
    Replies: 3
    Last Post: 05-19-2008, 08:41 PM
  5. Help with e-stop button
    By Astroguy in forum Xylotex
    Replies: 2
    Last Post: 05-31-2007, 01:23 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •