584,837 active members*
5,412 visitors online*
Register for free
Login
IndustryArena Forum > Community Club House > General Off Topic Discussions > Kitamura mycenter 0 axis over-travel
Results 1 to 2 of 2
  1. #1
    Join Date
    Jul 2005
    Posts
    207

    Kitamura mycenter 0 axis over-travel

    I managed to jog my Z too far (Towards the table) and now I am stuck with a E-stop alarm. Is there an easier way to jog it back off the limit other than removing the switch? The control is a yasnac i80m. I think its a 1996.

  2. #2
    Join Date
    Nov 2019
    Posts
    9

    Re: Kitamura mycenter 0 axis over-travel

    Since its been a while, you must have found the override temporary switch on the front of the control? Good luck!

Similar Threads

  1. Replies: 0
    Last Post: 03-14-2014, 03:15 PM
  2. Replies: 3
    Last Post: 08-08-2012, 11:05 AM
  3. Kitamura Mycenter 4th axis parameters
    By dmgood in forum Kitamura
    Replies: 0
    Last Post: 04-24-2012, 07:08 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •