584,802 active members*
4,926 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Kitamura > Kitamura mycenter 0 axis over-travel
Results 1 to 3 of 3
  1. #1
    Join Date
    Jul 2005
    Posts
    207

    Kitamura mycenter 0 axis over-travel

    I managed to jog my Z too far (Towards the table) and now I am stuck with a E-stop alarm. Is there an easier way to jog it back off the limit other than removing the switch? The control is a yasnac i80m. I think its a 1996.

  2. #2
    Join Date
    Mar 2011
    Posts
    3

    Re: Kitamura mycenter 0 axis over-travel

    There should be an OT release switch or button that you hold on whilst moving the axis back into range via the MPG. It may be in a remote position that requires two people.

  3. #3
    Join Date
    Jul 2010
    Posts
    7

    Re: Kitamura mycenter 0 axis over-travel

    The second limit switch release toggle is located on the bottom row of switches on the control. Its the farthest left on the panel. If I remember correctly you need to press reset then hold the toggle switch up and manually jog off the switch. Once your off the limit switch you will probably need to home all axis'.

Similar Threads

  1. Replies: 0
    Last Post: 03-14-2014, 03:15 PM
  2. Replies: 3
    Last Post: 08-08-2012, 11:05 AM
  3. Kitamura Mycenter 4th axis parameters
    By dmgood in forum Kitamura
    Replies: 0
    Last Post: 04-24-2012, 07:08 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •