[jnewton177]

hi

i am new to cam works, and i am trying to tap some holes on one of our older machines, and the post processor wont lent me output the tapping cycle in mm/Rev and keep outputting in mm/min
but its just breaking the taps as it can accelerate fast enough out of the hole

we used to have autodesk HSM which output in mm/rev for tapping and mm/min for drilling, but im pulling out my hair with it now =(

the control is a YASNAC i80 (basically fanuc canned cycles)


thanks in advance

Here is an example of what i want it to look like in the