Hi Guys
I'm used to using HAAS mill set ups which is literally "tool offset measure" and "Origin" buttons. Very simple.
The Fanuc seems a little more involved, I'm sure the principle is the same but it looks as though I need to punch in the coordinates etc.
I hope some of you guys can give me some tips on how to "touch off" the tool and "work offsets".
In my HAAS days it was just a matter of finding the middle of the work piece then press "Origin" then find the height of the work piece for each tool and press "offset measure".
Thanks guys
Bart
Results 1 to 3 of 3
-
07-03-2022, 07:55 AM #1
Registered
- Join Date
- Mar 2011
- Posts
- 230
Leadwell MCV-OP Fanuc OM controller. Setting up tool length and work offsets
-
07-03-2022, 06:42 PM #2
Banned
- Join Date
- Aug 2009
- Posts
- 1573
Re: Leadwell MCV-OP Fanuc OM controller. Setting up tool length and work offsets
...found a Manual for 0M Series control. Chapter 11.4 (about page 559) should explain the process.
http://servicetex.ru/wp-content/uplo...0%BA%D0%B0.PDF
-
07-04-2022, 08:48 AM #3
Registered
- Join Date
- Mar 2011
- Posts
- 230
Re: Leadwell MCV-OP Fanuc OM controller. Setting up tool length and work offsets
Oh wow thank you. This is great!
Originally Posted by machinehop5
Reply With QuoteSimilar Threads
-
ATC. Automatic Tool Changer issue. Leadwell Mill, MCV-OP Fanuc OM controller
By toranacar in forum FanucReplies: 43Last Post: 03-19-2023, 05:23 AM -
Setting tool length offsets without the wireless probe system
By LeeWay in forum Haas MillsReplies: 16Last Post: 06-19-2017, 11:46 PM -
Frusterated with Path Pilot and setting tool length offsets using my ATC
By wwendorf in forum Tormach PathPilot™Replies: 8Last Post: 02-28-2016, 07:54 PM -
setting lathe tool length offsets on ah ha control
By machinewerks in forum G-Code ProgramingReplies: 2Last Post: 02-28-2007, 04:09 AM
Tags for this Thread
Posting Permissions
