If I want to roughing away some of a casted epoxy block with a 10mm 2 flutes end mill, how deep cuts and which speed will be advisable for that purpose? I use only a Taig mill, so its not very strong force I´m dealing with.
If I want to roughing away some of a casted epoxy block with a 10mm 2 flutes end mill, how deep cuts and which speed will be advisable for that purpose? I use only a Taig mill, so its not very strong force I´m dealing with.
I am trying to get the most out of my Taig mill
diamond core bits are the way to go, with quite high rpms