[awilcox]

I am upgrading my cnc controller and drivers and I am seeking advice.

My current setup has:
- C10 bob
- OMS mh110 drivers
- Linux software

I am switching to:
- DM556D drivers
- UCCNC software

The configurations I am deciding between are:
- AXBB-E
- C76 bob w/ 300-eth
- UB-1 bob w/ 300-eth

Any feedback/advice would be greatly appreciated.

Adrian

[Jmhx2]

I am upgrading my cnc controller and drivers and I am seeking advice.

My current setup has:
- C10 bob
- OMS mh110 drivers
- Linux software

I am switching to:
- DM556D drivers
- UCCNC software

The configurations I am deciding between are:
- AXBB-E
- C76 bob w/ 300-eth
- UB-1 bob w/ 300-eth

Any feedback/advice would be greatly appreciated.

Adrian

I have just installed my second UC300eth-UB1. One in a router and the latest in a mill. I really like the layout of the board, sufficient number of I/O, 24VDC I/O, and the ease of install. I don't have any experience with the others.

[OlfCNC]

The AXBB-E is also nice.

[retrosmith]

I just finished installation of the AXBB-E on a CNC Router Parts Benchtop Pro 2436 and I love it. Nice not to need any breakout boards (unless you need the third port). It's worked flawlessly for me thus far.

[OlfCNC]

I agree, the AXBB-E is nice because it is an all in one solution saving lots of space and some cabling and it is 24Volts capable for industrial use.

[awilcox]

All,

Thanks for your feedback and help in deciding which direction to go. I will go with the AXBB-E configuration.

Adrian

- - - Updated - - -

All,

Thanks for your feedback and help in deciding which direction to go. I will go with the AXBB-E configuration.

Adrian