Hello.
Just got a "new" lathe.
Parameters was lost due to a bad battery.
I have put in all parameters from the book.
I can write programs and run them. BUT I cannot get the chuck to move its jaws with the pedals. It´s a hydraulic chuck.
When I actuate the valves manually it moves fine. The valves does not get any voltage when i use the pedals.
I think the SQ parameter is wrong, but I have searched all over and cannot find a value that works. With 512 I can run programs fine. With some other values I get errors when pressing cyclestart.
I have tested most of theese combinations 1, 2, 4, 8, 16, 32, 64, 128, 256, 512, 1024, 2048, 4096, 8192, 16384, 32768
Can anyone help me?
/Andreas
email: [email protected]