Good morning all,
I looked over the website and even the DOCs but still not sure (perhaps because I want this)...
Is the UCC software able to control lathes?
Can two MPGs be used at the same time with the UCC software?
Thanks
Chris
Good morning all,
I looked over the website and even the DOCs but still not sure (perhaps because I want this)...
Is the UCC software able to control lathes?
Can two MPGs be used at the same time with the UCC software?
Thanks
Chris
There is no lathe mode, but some people have used it for lathes.
UCCNC currently only supports one MPG.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks Gerry,
I was afraid of that. I guess it is time to look into LinuxCNC.
Chris D