504,228 active members
5,320 visitors online
Register for free
Results 1 to 1 of 1
  1. #1
    Join Date
    Dec 2016

    Bridgeport R2E4 Boss 10 Series II Parts

    I retrofitted my mill to Linux and I have all the old parts leftover from the original machine. There was a problem with the driver boards which would cause an intermittent fault, I'm not sure what the issue was since I never tried to diagnose it. Other than that the machine ran fine, and had very low hours. I'm not posting prices because I don't want much for any of it, I'd rather not give the parts away, but I'd also rather not throw them away.

    The screen and control board was replaced by the previous owner and only has a few hours of use on it. I have the stock encoders as well.
    Attached Thumbnails Attached Thumbnails R2E4 Parts.jpg  

Similar Threads

  1. Replies: 0
    Last Post: 02-12-2015, 12:22 AM
  2. Bridgeport Series 1 R2E4 Boss 8
    By bevins in forum Bridgeport / Hardinge Mills
    Replies: 13
    Last Post: 01-07-2014, 10:33 PM
  3. Need Help Bridgeport R2E4 Boss 9
    By weldthis in forum Bridgeport / Hardinge Mills
    Replies: 10
    Last Post: 10-16-2011, 05:15 PM
  4. Bridgeport r2e4 Boss 9 Parts for sale
    By weldthis in forum Bridgeport / Hardinge Mills
    Replies: 5
    Last Post: 08-17-2011, 04:42 PM
  5. BridgePort Series I CNC BOSS 9 / R2E4 Problems
    By gbarker in forum Bridgeport / Hardinge Mills
    Replies: 8
    Last Post: 06-18-2010, 11:51 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts