Dear sir,
We have fanuc tape cut mate om control 1986 model. We are faceing with frequent wire break and feed rate running very slow. How to over come this problem or any setting parameter editing required. Please tell any suggestion to over come this problem. Or any chat with different thicknesses
Edm paramter
No ;8
Type; 0
Voltage:8
Capacity ;8
On time:4
Off time:45
V. Servo:16
W. Feed:8
Sec cut;0

Please tell any correction required in above paramter to over wire break and high speed feedrate

Thanking you,
G Anjaiah
India