Found a listing for an no longer used automated gluing machine which uses a PRO 4824 for the motion components, some Mitsubishi NEMA34 servos and controls. I think it was a good deal at $750 even though I am at a loss as far working with electronics.
My original thought was to gut it for the linear rails and upgrade my V-CON 4848, but the wiring layout and electronics are so cleanly done that I may just keep it as is and convert it to a router. I expect the servos to be overkill given that I never had any complaints with my G540 NEMA23 setup. Anyway, I thought I'd share, I am sure I'll be asking for help.
Results 1 to 3 of 3
-
08-28-2019, 12:51 AM #1
Registered
- Join Date
- Aug 2005
- Posts
- 58
New to me PRO 4824 w/ Servos! build thread?
-
08-28-2019, 02:47 AM #2
Member
- Join Date
- Feb 2005
- Posts
- 829
Re: New to me PRO 4824 w/ Servos! build thread?
Nice FIND!!!
The servos are probably overkill on power, but might be fantastically accurate.
-
08-31-2019, 11:08 PM #3
- Join Date
- Jun 2019
- Posts
- 4
Re: New to me PRO 4824 w/ Servos! build thread?
What an amazing deal
Reply With QuoteSimilar Threads
-
PRO 4824 Build in Tennessee
By klhoard in forum Avid CNCReplies: 44Last Post: 06-03-2017, 07:38 PM -
Pro 4824 Build & Upgrade
By GigaWatt in forum Avid CNCReplies: 42Last Post: 05-04-2017, 08:37 PM -
Another Pro 4824 Build
By GigaWatt in forum Avid CNCReplies: 3Last Post: 04-09-2016, 12:43 AM -
New 4824 build here
By Carol in AZ in forum Avid CNCReplies: 0Last Post: 07-19-2015, 02:43 PM -
another servos V/S stepper V/S R&P V/s ballscrew thread
By lgalla in forum Linear and Rotary MotionReplies: 35Last Post: 12-10-2009, 04:22 AM
Tags for this Thread
Posting Permissions
