Hello
I am about to convert my Rover 23 with Mach3, does anyone have knowlegde of what card to use? And what more stuff I need to buy?
To begin with, I just want XYZ, motor and toolchanger to work but later on also all other stuff.
Hello
I am about to convert my Rover 23 with Mach3, does anyone have knowlegde of what card to use? And what more stuff I need to buy?
To begin with, I just want XYZ, motor and toolchanger to work but later on also all other stuff.
There has been a couple of these machines converted to LinuxCNC and there are build threads on the Linuxcnc forum. There is a much greater range off reasonably priced controller options with LinuxCNC. Pretty sure from what was said they are 0-10 volt analog servos so a Mesa 7i77 will take care of the motion side. Depending on if you want to connect via Ethernet or via PCI/PCIe will determine if you use a 7i92 (ethernet), 5i25 (PCI)or 6i25 (PCIe) to connect it to the PC.
Rod Webster
www.vehiclemods.net.au
Here are some movies from the Biesse with new servos and mach3
https://www.dropbox.com/s/v8flhnwk02...09.50.mov?dl=0
https://www.dropbox.com/s/7joa9g4qqq...02.09.mov?dl=0
Since the servos has been replaced, if anyone is interested of the old servos, feel free to contact me.
SGDB-20VN
SGDB-02VN
SGDB-15VN
SGDB-10VN
SGMP-15V316CT
SGMG-09V
SGMG-20V
SGMP-02V3YG11