Hello,
I have recently received my OMNI 1315 CNC Router and I am unable to use it because I am uncertain as to how to wire it. My machine is single phase 220V. I am in North America where we use 2 110V lines to create 220V between them. OMNI is very difficult to communicate with and regarding this seemingly simple issue they can not offer anything of value. I'm very concerned because I don't want to risk damaging any electrical components. I have attached an image of my terminal bar. The 2 wires are labeled L1 and N. I understand that the L1 is for 1 110V hot line but I'm confused about the N. OMNI says it's a 'zero line' aka neutral. If it is a neutral then where does my second 110V hot line go if there is no L2? Others have told me that it doesn't need a neutral, just a ground, and that I'd put my second hot into the N terminal. Can anyone please offer some advice? OMNI seems very reluctant to help and I don't quite trust what they are telling me because they seem so unsure and inexperienced with this issue. I'd be glad to offer any more information if it helps resolve this issue. Thank you.