Originally Posted by
jayrod7387
Those drawings of my table are very impressive! that being said I feel like the table frame itself is VERY sturdy. is there a way i could prove/test that it is or isnt?
As far as current/control, how would i verify that that is right? my steppers do get pretty warm when sitting there active for a short time or running just a few cuts. Is that normal? Im running a Gecko G540 controller with 48v 10.5a power supply. controlled through parallel port(mach3). I know it needs resistors, I have the cables with built in resistors provided by cncrouterparts. Maybe i need to verify the resistor values?