Does anyone have instructions or a schematic on where to install and how to wire the 4th axis inhibit board?
This is for an older DC machine and running a DC 4th axis.
Thanks,
Richard
Does anyone have instructions or a schematic on where to install and how to wire the 4th axis inhibit board?
This is for an older DC machine and running a DC 4th axis.
Thanks,
Richard
Here is a link, I think can help you. https://www.wiringo.com/custom-wiring-harness
Have a look at those pix. See if you can find anything remotely close to what you need to see.
https://www.google.com/search?rlz=1C...w=1280&bih=625
Full disclosure; this is not spam
Go to "FADALCNC.COM" click on "Technical docs". In the lower left you'll see the Header for Wiring diagrams. Click on 4th axis servo options. Page 5 shows you the wiring diagram for the inhibit curcuit.
In the "Technical tips" section, look under R for rotary and there is a pdf that explains the Inhibit curcuit and where it locates in the cabinet.
Installation guide https://docs.wixstatic.com/ugd/b812a...caeeaeb47e.pdf
Got it, thanks. The left side of the cabinet is where all my Renishaw components are mounted. I ended up putting it in the big empty area to the right side of the power supply. I know it seemed like a trivial issue but I kind of like keeping things where they go.
It is funny that out of all the dozens and dozens of control panel pictures out there, I did not find one that had this inhibit circuit. I take it this was something that was added later as an improvement?
Richard