[wahidbashir]

Dear All,
I have installed a new CPU board JANCD-CPO3B in Mori Seiki MV 35/40.
On First power application display comes but after 10 seconds it disappeared.
On checking i have found that its board ICs heating up very fast.
Its board supply is correct and in given tolerance like 4.955 V, 12 V and 24V.
I have tested this CPU board in my lab by providing only 5V separate suppply but
same result.
Can any one tell me how to sort out this problem ?


Warm Regards

[dll6]

I'm replying to a very old thread hoping for a miracle.
JANCD-CP01 in my mv35/40 are the cp01 and cp03b boards really interchangeable?
Don't suppose your willing to share how this nightmare ended?
Thank you for your time.

[dll6]

I've made progress on my problem. I did a memory regeneration and re entered all the parameters and am getting closer. Updated information here ... Well it won't let me post the link so search practical machinist dot com for
"mori seiki sl-2 no-power to nc"