[jolulank]

Hello,
I have a Fadal 4020 CNC 88
Model 906-1
Serial 9205252

It is a 4020 but the axes only move 20 10 and Z Also moves half the distance.
I want to access the Machine configuration and the diagnostics mode but the control asks for an access code.

Does anyone knows?
Thanks

jolulank

Enviado desde mi Redmi 5 Plus mediante Tapatalk

[Tedger]

Perhaps yor parameters are wrong. Can you type "SETP" at the command line to double check them?

[jolulank]

Perhaps yor parameters are wrong. Can you type "SETP" at the command line to double check them?

In fact the parameters are wrong, but some parameters I can not change without the access code ir password

Enviado desde mi Redmi 5 Plus mediante Tapatalk

[rodney247]

Is there no key in the pendant? Sometimes the Keys are wired tied inside the Main cabinet. you need the key

[rodney247]

Or if you can not find the keys ... its easy to bypass just open the Pendant i can't remember if the circuit is closed for lock or open... so either connect the wires or separate them that run to the lock. Done. its a very simple on/off type circuit.