Want to purchase a 1 axis closed loop driver/motor set for Z axis on my mill.
Would appreciate your opinions/recommendations please.
At the moment I'm looking at buying this one but open to suggestions.
https://www.ebay.co.uk/itm/Closed-Lo...0AAOSw3GBcxWAh

I have a 60VDC power supply in my control box to run it from.


The bog standard stepper set I have at the moment has too much torque (12nm) by the sounds of it.
Resonance issues make it practically unusable. 8mh inductance figure isn't helping either I reckon.


Thanks in advance.